ATS resume checker for CNC Programmer roles
We are looking for a CNC Programmer to program and set up CNC machines for production parts. You will select tooling and optimise cycle times, and inspect first-off parts and maintain machine health. Required: hands-on experience with G-code programming, CAM programming, Tooling selection, Machine setup, and working knowledge of Mastercam, Fusion 360, Fanuc controls. Preferred: Diploma in Mechanical or CNC certification or ITI Machinist. Success in this role is measured by cycle time per part, scrap rate, machine utilisation.
Skills screened
- G-code programming
- CAM programming
- Tooling selection
- Machine setup
- Fixture design
- Dimensional inspection
- Cycle time optimisation
- Preventive machine care
Tools
- Mastercam
- Fusion 360
- Fanuc controls
- Siemens controls
Qualifications
- Diploma in Mechanical
- CNC certification
- ITI Machinist
Questions
Which keywords should a CNC Programmer resume include?
Pull them from the specific job description first. Across most CNC Programmer postings the recurring terms are G-code programming, CAM programming, Tooling selection, Machine setup, Fixture design, Dimensional inspection, plus tools such as Mastercam, Fusion 360, Fanuc controls. ResumeScanner extracts the exact set from the JD you paste rather than relying on a generic list.
What match score is good for CNC Programmer roles?
Anything above 75% usually means your resume covers the required skills and the seniority band. Below 60% there is normally a real gap — missing CAM programming or Mastercam experience — not just a wording problem. We show the reasoning behind the score so you can tell the two apart.
How do I quantify CNC Programmer experience?
Tie each bullet to one of cycle time per part, scrap rate, machine utilisation. Even approximate figures beat none: reviewers read them as evidence you tracked outcomes.
Do Diploma in Mechanical certifications matter for this role?
They rarely replace experience, but they break ties. When Diploma in Mechanical appears in a JD's preferred list, our checker flags it as a missing keyword if your resume does not mention it.
Should I use a different resume for each CNC Programmer application?
Not a different resume — a re-aligned one. Titles vary (CNC Machinist, NC Programmer) and so do required tools. Re-running the check per JD takes seconds and normally surfaces two or three swaps worth making.